Hi all
I just replaced the cable that goes from Optimum's outside connector to my modem direct, with quad shield RG6. Here is a screen shot after 2 plus hours (attached).
What's going on with these errors?????
I replaced the cable because of dropped connections and slow speeds at times.
But now that I have a direct connection, I'm still getting errors (although the power levels went up quite a bit, from averaging -8 downstream to the attached)
Will Optimum come out and attempt to fix these errors even though I showing good Signal Strength and good SNR??
Over 1 million errors ??? But internet seems ok? Voip seems ok too??
Connection
Startup Sequence
Startup Step Status Comment
Acquire Downstream Channel 609000000 Hz Locked
Upstream Connection OK Operational
Boot State OK Operational
Configuration File OK ^1/DB9F2F14/
Security Enabled BPI+
Connection Status
System Up Time 0 days 02h:12m:57s
Network Access Allowed
Downstream Bonded Channels
Channel Lock Status Modulation Channel ID Freq. (MHz) Pwr (dBmV) SNR (dB) Corrected Uncorrected
1 Locked QAM256 6 609.0 1.7 39.3 2 0
2 Locked QAM256 1 567.0 1.8 41.0 61 0
3 Locked QAM256 2 573.0 2.1 41.3 25 0
4 Locked QAM256 3 579.0 2.2 41.5 1 0
5 Locked QAM256 4 585.0 0.8 39.9 78 29
6 Locked QAM256 5 603.0 2.0 38.6 9218 0
7 Locked QAM256 7 615.0 1.3 39.8 5 0
8 Locked QAM256 8 621.0 1.3 40.7 46 1
9 Locked QAM256 9 627.0 1.7 38.8 16 0
10 Locked QAM256 10 633.0 1.2 40.5 18 0
11 Locked QAM256 15 663.0 1.3 40.6 1 0
12 Locked QAM256 17 675.0 0.7 39.8 2 0
13 Locked QAM256 18 681.0 1.1 40.4 5 0
14 Locked QAM256 19 687.0 -0.6 39.9 10 0
15 Locked QAM256 22 705.0 -1.2 39.6 197640 740909
16 Locked QAM256 23 711.0 -1.3 39.5 186601 655660
Total 393729 1396599
Upstream Bonded Channels
Channel Lock Status Channel Type Channel ID Symb. Rate (Ksym/sec) Freq. (MHz) Pwr (dBmV)
1 Locked ATDMA 45 5120 14.0 47.8
2 Locked ATDMA 42 5120 35.0 49.0
3 Locked ATDMA 43 5120 28.4 46.8
4 Locked ATDMA 44 5120 22.0 46.0
Downstream Frequency Setting
Downstream Frequency Select
↧